ALSA quirks.c:609 >usb-audio: Digidesign Mbox 2: 24bit 48kHz ALSA quirks.c:584 usb-audio: device not ready, resending boot sequence… ALSA quirks.c:573 usb-audio: Sending Digidesign Mbox 2 boot sequence… usb 2-1.2: config 1 interface 5 has no altsetting 1 usb 2-1.2: config 1 interface 4 has no altsetting 1 usb 2-1.2: config 1 interface 3 has no altsetting 1 usb 2-1.2: config 1 interface 2 has no altsetting 1 usb 2-1.2: new full-speed USB device number 9 using ehci_hcd I know this thread hasn’t seen any action in awhile, but am getting this in dmesg when I plug in the MBox 2 Mini: That’s why I’m trying to compile the driver again. I reinstalled everything because the last ubuntu kernel is supposed to work fine with mbox2, but it doesn’t: Make: Leaving directory `/usr/src/linux-headers-3.11.0-13-generic’ home/hellmenda/Desktop/mbox2-kernel/urb.c:475:8: note: each undeclared identifier is reported only once for each function it appears in home/hellmenda/Desktop/mbox2-kernel/urb.c:475:8: error: ‘oldbytes’ undeclared (first use in this function) home/hellmenda/Desktop/mbox2-kernel/urb.c: In function ‘retire_capture_urb’: Make: Entering directory `/usr/src/linux-headers-3.11.0-13-generic’ĬC /home/hellmenda/Desktop/mbox2-kernel/urb.o Make -C /lib/modules/3.11.0-13-generic/build M=/home/hellmenda/Desktop/mbox2-kernel modules
Hello, so sorry to trouble you with this issues, but when trying to compile, I get this make Without the update, I have experienced strange noisy inputs with the Mbox2 on GNU/Linux but when I applied the update the noise disappeared… I only just realised this, but you need to upgrade your Mbox 2 firmware to v1.43 using the official updates provided here( Avid) and mirrored on my site here( win64), here( osx_intel) and here( osx_ppc). Any config issues with JACK, make sure you are using the ALSA backend and 2 ins and 2 outs, >256 buffer size and 3 periods. None of the above instructions are relevant anymore because the Mbox2 driver stuff is part of Linux kernel after 3.8! Just plug in your device, lights come on and it works. That’s right folks, if you install a kernel later than 3.8-rc2, your Mbox2 will work right out of the box with Linux! Sudo rmmod snd-usbmidi-lib # ignore errors Then do the following: (extract the tarball to ANY directory then “make” it, install it and modprobe the new driver as follows:) Make sure you have the kernel headers downloaded and installed correctly. It can be compiledįor the current running kernel as follows: Every little bit counts.įor those of you who want the raw driver source, here it is as a kernel module. Please consider donating $5 for further development of free software drivers for Digidesign hardware. This is my unofficial Digidesign Mbox 2 driver for linux.
0 kommentar(er)
